Elnec SEEprog, Руководство пользователя

Страница: 58 / 171

ELNEC s. r. o.
Technical specification
HARDWARE
Programmer
•
two D/A converters for VCCP and VPP, controllable rise and fall time
•
VCCP range 0..7V/350mA
•
VPP range 0..25V/200mA
•
USB 2.0/1.1 compatible interface
•
selftest capability
ZIF socket, pindriver
•
40-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 40-pins
•
pindriver: 40 TTL pindrivers, specialized GND/VCC/VPP pindriver
•
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins, level H
selectable from 1.8 V up to 5V
•
continuity test: each pin is tested before every programming operation
ISP connector (useable after upgrade to SmartProg2 only)
•
10-pin male type with miss insertion lock
•
6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to
5V to handle all (low-voltage including) devices.
•
1x VCCP voltage (range 2V..7V/100mA) and 1x VPP voltage (range 2V..25V/50mA)
•
programmed chip voltage (VCCP) with both source/sink capability and voltage sense
DEVICE SUPPORT
Programmer
•
EPROM: NMOS/CMOS, 2708(*3), 27xxx and 27Cxxx series, with 8/16 bit data width, full
support of LV series (*1*2)
•
EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series, with 8/16 bit data width, full
support of LV series (*1*2)
•
Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx, 29Wxxx, 49Fxxx series, with
8/16 bit data width, full support of LV series (*1*2)
•
Serial E(E)PROM: 24Cxxx, 24Fxxx, 25Cxxx, 45Dxxx, 59Cxxx, 25Fxxx, 25Pxxx, NVM3060,
MDA206x (*3), 85xxx, 93Cxxx, full support for LV series (*1)
•
Configuration (EE)PROM: 37LVxx, XC17xxxx, AT17xxx, LV series including (*1)
•
NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD U63x
series
Notes:
•
(*1) - suitable adapters are available for non-DIL packages
•
(*2) - there exist only few adapters for devices with more than 40 pins. Therefore think
please about more powerful programmer(BeeProg2 / BeeProg2C / ), if you
need to program devices with more than 40 pins
•
(*3) - programming with additional module
58