Elnec SEEprog, Руководство пользователя

Страница: 22 / 171

ELNEC s. r. o.
The above mentioned values are provided to understand (and also to exactly calculate) the
value of resistors, which isolate (separate) the programmed chip and target system.
Specification of ISP connector pins depends on the device, which you want to program. You
can find it in the control SW for programmer (PG4UW), menu
Device / Device Info (Ctrl+F1) .
Be aware, the ISP programming way of respective device must be selected. It is indicated by
(ISP) suffix after name of selected device.
These specifications correspond with application notes published of device manufacturers.
Used application notes you may find on
www.elnec.com , section Support / Application
Notes .
Note: Pin no. 1 is signed by triangle scratch on ISP cable connectors .
As ISP connectors are used 20 pins connectors 09185207813 from Harting or other
compatible connector.
BeeHive204 ISP cable
Warnings:
•
Use only attached ISP cable . When you use other ISP cable (other material, length…),
programming may occur unreliable.
•
BeeHive204 can supply programmed device (pin 1 of ISP connector) and target system
(pins 19 and 20 of ISP connector) with limitation (see Technical specification / ISP
connector).
•
BeeHive204 apply programming voltage to target device and checks his value (target
system can modify programming voltage). If the programming voltage is different as
expected, no action with target device will be executed.
Selftest and calibration check
If you feel that your programmer does not react according to your expectation, please run the
programmer (ISP connector) selftest using Diagnostic POD (Diagnostic POD for ISP
connectors #2), enclosed with the standard delivery package.
Selftest of programmer
•
Insert 48 pins diagnostic POD - type I into ZIF socket of the programmer. 48 pins
diagnostic POD - type I must be inserted as 48 pins device.
•
Run selftest of programmer in PG4UW (Programmer / Selftest plus).
22