Elnec SEEprog, Руководство пользователя

Страница: 125 / 171

PG4UW
Programmer
Menu Programmer includes commands used for work with programmers.
Programmer / Find programmer
This item selects a new type of programmer and communication parameters. This command
contains following items:
Programmer - sets a new type of programmer for find. If a Search all is selected, the control
program finds all supported programmers.
Establish communication - allows manual or automatic establishing communication for a
new programmer.
Speed - sets speed, if a manual establishing communication is selected, which PC sends
data into the programmer. Speed is expressed as a percent from a maximal speed.
The communication speed modification is important for PCs with "slow" LPT ports, which
haven't sufficient driving power for a PC<->programmer cable (laptop, notebook, ...). Use this
command, if you have any communication problems with connected programmer on the LPT
port of your PC (e.g. control program reports a programmer absence, the communication with
the programmer is unreliable, etc.).
If automatic establishing communication is selected, then control program sets a maximal
communication speed.
Note: Items Establish communication and Speed are available only for SEEprog.
Port - selects a port, which will be scanned for a requested programmer. If All port is
selected, the control program scans all ports, which are available on standard addresses.
Address for special port - sets address of LPT port, if a Special port is selected.
Pressing key
<Enter> or button OK initiates scanning for programmer by set parameters.
There is same activity as at start the control program. The command clears a list of default
devices without the current device, if the new selected programmer supports this one.
This setting is saved to disk by command
Options / Save options .
Programmer / Refind programmer
This menu command is used to refind (reestablish communication with) currently selected
programmer.
To select other type of programmer, programmer communication parameters and to establish
communication with newly selected programmer use menu
Programmer / Find
programmer .
Programmer / Handler
In dialog Handler a Handler type and Handler communication parameters can be set.
Handler is an external device for special control of device operations in control program.
When
None Handler is selected, this means default state of control program, i.e. device
125