PG4UWMC software
127
Main window of PG4UWMC consists of following parts:
Menu and tool buttons
Menu and tool buttons allow access to most of PG4UWMC functions.
Tool button Settings
Button is used to open PG4UWMC Settings dialog. Settings dialog is described below.
Panels Site #1, Site #2,...
Panels are used to inform about:
Programmer Site selected
Programmer Site activity
current device operation status and/or result
Each panel also contains button
Run
or button
YES!
used to start device operation.
Box Statistics
Box Statistics informs about number of programmed devices and number of good and failed
devices.
Note: 'Reset statistics' button is disabled until any action is running on sites. To stop action
on sites press button 'Stop All'.
Checksum
Checksum is showing simple checksum of data loaded from current project file.
Panel Status window
Panel Status window informs about current state of each Site. State can be
Blank
Site is no active
Ready
Site is active and ready to work. Programmer is connected. No device
operation is running.
and other information
currently running device operation, result, programmer connection
state and so on
Log window
on the right side of Status window
Log window contains information about connecting/disconnecting programmers, device
operation results and other information.
Button Connect programmers
Button is used to connect all selected Programmer Sites. This button is usually used as the
first step after starting PG4UW MC.
Button Disconnect programmers
Button is used to disconnect all connected Programmer Sites and close Programmer Sites
control programs. The button will apply only if no device operation is currently running on any
connected programmer.
Button Run <operation>
Button is used to start device operations on all connected programmers at the same time.
The value of <operation> can be one of following types: Program, Verify, Blank check, Erase.
Содержание BeeHive304
