Elite Greenhouses TITAN K800, Инструкции и иллюстрации

Страница: 28 / 36

5 BLADE LOUVRE
Procedure
1. Place top cill into position on side jamb of louvre and se-
cure with self tapping screws.
2. Do same on the other top corner.
3. Do same with bottom cill.
4. Please note that the handle is on the right hand side, the
above diagrams are viewed from the middle.
5. To fit the louvre to the structure, utilise the extra bolts you
inserted during side frame assembly. Insert a glass pane at the
bottom, bolt the louvre to the framework and slide it down so
that the bottom cill of the louvre frame is touching the pane of
glass.
INSTALLATION OF 5 BLADE LOUVRE
The louvre can be installed to either the fixed gable end or
front assembly (but must be between 2 glazing bars, not corner bars). This position might not be
variable depending upon your door position.
1. The louvre must be fitted after the unit has been fully assembled and anchored to the wall and
base, and prior to glazing.
2. The louvre is fitted to the glazing bars of the fixed gable end utilis-
ing the 4 unoccupied bolts previously inserted into the bolt slots of the
glazing bars concerned during original assembly.
3. The louvre is fitted from the inside of the structure with the angle
jambs fitting around the glazing bar.
N.B. The handle is on the inside of
the greenhouse and the right hand side as viewed from inside the struc-
ture.
4. To determine the height, install a pane of glass under the louvre
(glass size dependant upon desired louvre height- see relevant glazing
plan).
5. Inside the fitting you will have 4 louvre clamps/louvre.
6. Using the previously inserted bolts (or using 1/2 head bolts supplied)
loosely fit the 4 brackets as shown to the greenhouse frame, and then
tighten so as to clamp the louvre frame to the greenhouse.
7. Offer the louvre frame to the bolts; add the nuts and finger tip tight-
en.
8. Slide the completed framework to the top of the pane of glass so that
the bottom cill of the louvre rests on the glass.
9. Tighten all nuts.
10. Louvre frame installation is now complete.
GLAZING THE LOUVRE
1. The louvre must be glazed after it has been installed to the structure.
2. Open the louvre using the handle.
3. Slide each individual blade of glass between the jambs into the aluminium holders.
4. The glass will come to rest in the holder at the bottom of the jambs.
Partition—You can now build your partition starting with the wall bar and cill. When these are fit-
ted attach the glazing bars and door configuration as previously done in the door end assembly.