Elite Greenhouses TITAN K800, Инструкции и иллюстрации

Страница: 20 / 36

The vent slam can now be fitted to the two roof bars just underneath the bottom rail of the vent.
The ends of the slam bar are cut out to go round the profile of the roof glazing bar. Secure the slam
bar with the top bolt in each bar that the vent is fitted, that were inserted when you fitted the bottom
of the roof bars to the eave.
The slam bar is an unequal angle and it attaches to the roof with the longer part of the angle point-
ing skywards, i.e. toward the bottom rail of the vent, and the shorter part of the angle pointing to the
gutter, i.e. the outside corner of the angle is facing inside the structure.
(Key point) .
To prevent the vent moving left/right during operation, insert a bead of silicone into the hinge part
of the ridge at the end of the vent top rail. This can be done later when sealing the frame to the wall
(see page 22).
1. On all models there are 2 top hat roof sections that are fitted along the length of the greenhouse.
2. Each top hat has 2 holes every 2’ to match the hole spacing of the gutter and ridge.
3. An extra pair of hands would be useful at this stage.
4. Line up the holes with the previously inserted bolts in each roof corner and glazing bar and posi-
tion 1 top hat directly under the vent slam bar and the 2nd top hat approximately 700mm up from
the eave.
5. If you have a partition, then the top hats will be pre-cut to enable fixing around the partition cor-
ner bars. One top hat will have a flat cut at each end, and the 2nd (the extension) will be notched at
1 end only. The notched end will fix to the ‘outside’ of the partition corner bar. (Outside of the cor-
ner bar is the side of the partition that the door slides).