Elite Greenhouses 6'3" WIDE HIGH EAVE, Инструкции и иллюстрации

Страница: 29 / 32

FULL SHEET TOUGHENED GLASS (EN12150
).
If you have purchased bar capping as an optional extra, see separate instructions with the capping
for fitting instructions. A wire clip is used when bar capping is fitted and these clips will be found
inside the bar capping box.
The main differences in application between the two types of glazing are:
1. Toughened glass is in large sheets.
2. There are no overlaps: where there are two or more panes in a section they are butt jointed
with a P.V.C overlap strip – (called a muntin) – you do not use muntins or spacers if you
have multi-sheet (or small pane) toughened glass.
3. See the diagram for the position of the different sizes.
4. The glass is clipped onto the frame in the same way as the horticultural glass is, but use 8
clips per large pane.
5. Put the P.V.C overlap piece (muntin) on top of the lower pane making
sure you have differentiated between the inside and outside of the
P.V.C (see diagram below). The next pane sits on top of the overlap
and is clipped in as normal.
6. The roof panes have a PVC ‘spacer’. Fit 1 roof spacer to the top edge of each roof panel
(except where a vent is installed). Slide the glass with spacer under the ridge as far as it will go
and then lower into the recess in the gutter/eaves bar. The spacer slides underneath the beading
channel of the ridge bar.
N.B Spacers and muntins will be found in the packets
of cut size glass (where appropriate).