Elite Greenhouses 6'3" WIDE HIGH EAVE, Инструкции и иллюстрации

Страница: 12 / 32

DOOR END ASSEMBLY
Components
1 Door end cill
2 Built in base cill
2 End glazing bars (longer than rear end glazing
bars)
2 Rectangular plates with 3 slotted holes
2 Short horizontal braces
2 Roof corner bars (marked ‘R’)
2 Side corner bars (unmarked)
1 Door track support
1 Top door track
1 Small angle door track support
From the main bag of fittings you will require the nuts and bolts.
You will also require 2 eave plates and 1 ridge plate. These are packed with the casement stay and
are separated from the main bag of fittings.
INSTRUCTIONS
1. Assemble the frame in exactly the same way as the rear end, up to and including stage 3 of the
rear end. The difference with the door end is that instead of 1 long base piece, the door end
has 2 smaller pieces (1 either side of the door opening) and 1 door end cill. The end glazing
bars on the door end are longer than the rear end glazing bars.
2. Now engage the door end cill with the 2 built in base cills by pushing the angle of the cill
under the locator as shown in the diagram. At this stage the cill will move freely left and right
but will remain located to the built in base cill.
NB: The short door end base sections have an extra slotted hole at the other end which will not
be utilised in the assembly, but is there so that the base pieces do not require handing i.e. left
can go on right and visa versa.
3. Slide 2 bolts into the bottom of each glazing bar and 3 bolts (only 1 if greenhouse to be sited
on soft ground) into the free end of each built in base section. Attach the 2
nd
bolt in the glaz-
ing bar to the hole in the door end cill, but do not put a nut on yet.