Elite Greenhouses 6'3" WIDE HIGH EAVE, Инструкции и иллюстрации

Страница: 26 / 32

8. Now attach the aluminium base to the 2 side base sections of the greenhouse. Firstly bolt an
anchor bracket on each end of the partition base. If you are on flags or concrete cut off the
surplus metal of the corner bracket. Position the base under the partition cill and attach it to
the side base walls by inserting a bolt into each bolt slot of the side base. Line the corner
bracket angle up with the bolt slots, put nuts on and prior to tightening move the partition base
in or out to line up with the built in base cill. Tighten the nuts.
9.
Thread the glazing beading into the channels and trim to suit. Put 3 bolts into each bolt slot,
attach to the bottom cill by inserting another bolt into the slot and pushing it through the hole
in the bottom cill. Moving to the top of the bar, insert another bolt into the bolt slot and out
through the hole in the roof corner bar. Put a nut on finger tip tight. Do the same with the
other glazing bar.
10. Utilising the 3 extra bolts inserted into each bar, attach the horizontal and diagonal bracing
bars in the same way as the original door end. Likewise with the door track support (to be
found with the door panels) attach as before. The doors in a partition are a little shorter than a
standard door to facilitate full opening. For door assembly refer to double door fitting sheet,
this can be found with the bag of fittings for the partition.
For both single, double and partition door ends you can now fit the upper door track.
PARTITION DOOR TRACK
This top door track has no holes in but one bolt slot. Insert 3 bolts into the bolt slot and line them
up with the 3 holes in the door track support, put the nuts on and tighten up. To position the door
track into the correct position fit the partition doors onto the track and by slightly releasing the 2
nuts holding the door track support you can move the door up and down until it is correctly into the
bottom guide. Having achieved the correct position of the doors you can now attach the angle
bracket to the right hand roof corner bar to support the end of the door track. The door should now
run smoothly. If not you can “fine tune” its operation by re-adjusting the bolts up and down slight-
ly.