Elite Greenhouses 6'3" WIDE HIGH EAVE, Инструкции и иллюстрации

Страница: 22 / 32

9. Slide the glazing beading into the V groove of the roof glazing bars. They can now be
attached to the ridge and gutter. Attach them to the ridge first by sliding a bolt into the
bolt slot of the glazing bar, inserting it through the hole in the flange of the ridge. Put a
nut on and tighten up. Do the same with the rest of the roof bar. N.B. remember to omit
two roof bars if you have a partition, one each side.
10. Before bolting the bottom of the roof bar
to the flange of the eave bar, insert extra
bolts as follows. Then attach the final
nut and bolt to the eave bar as illustrated.
Where the vent is to be positioned put an
extra one bolt per bar i.e. the vent covers
two glazing bars so two extra bolts per
vent.
(Key point ). One each bar.
If your greenhouse is 8’5”, 10’5” or
12’5” long you have additional cantilever
bracing at the eave, 2 brackets for 8’5”, 4
for the 10’5” and 6 for the 12’5”.
Put an extra bolt into the 2
nd
glazing bar
(8’ model), 2
nd
and 3
rd
for 10 model, and
2
nd
, 3
rd
and 4
th
for 12’ model before at-
taching the glazing bar to the eave. (Key
point).
11. Before sliding the vent onto the ridge, slide a piece of vent tube into the vent hinge sock-
et. Slide the vent onto the ridge from either end and into the desired position.
The hinge is a ball and socket joint, the ball being on the top rail of the vent, the socket
on either side if the ridge running the full length of the structure.
(Key point).
The vent can go in any position (but if you have 2 or more, they cannot be adjacent) on
either side of the ridge. Fit the slam bar immediately under the vent bottom rail and se-
cure with the bolts previously inserted in the roof bars. The precise position of the slam
bar can be determined by inserting a pane of glass ref A under the vent and moving the
slam bar down to touch the glass.
12. Do not fit the door at this stage.