Eliet MA 018 010 130, Руководство пользователя

Страница: 58 / 69

58
English
To renew the blades, proceed as follows.
• The new set of RESIST PRO TM blades can be obtained from your ELIET dealer by stating the
article number BU 101 300 900.
• Renewing the blades simply consist of removing the old blades and refi tting new blades.
• First remove any dirt between the blade plates before inserting a new blade. To do so, use a
stripping knife.
• Respect their rules stated for reversing the blades.
• If the blades are renewed, always fi t new bolts and nuts.
General comments
• When fi tting the blades, you must fi rmly tighten the bolts (torque to 76 Nm).
• In particular, do not forget to make sure that nuts (1) are positioned on the left-hand side when
the mounting the blades. Reminder : “The nuts must be positioned on the key way (2) side, or on
the pulley side.
• After reversing or renewing the blades, always check the tension of the blade bolts after the
fi rst 5 operating hours, and if necessary, tighten them.
Caution:
Blades that are incorrectly or badly mounted can cause damage to the machine.
Moreover, they pose a danger to operators and bystanders.
Failure to retighten the blades after the fi rst 5 operating hours after reversing or
renewing the blades, can cause serious damage to the machine.
The owner is not entitled to make any claim for damage and consequential loss
under the warranty if this results from inadequate maintenance of the blades.