Eliet MA 018 010 130, Руководство пользователя

Страница: 43 / 69

43
English
11.3.2.2 Refi tting the large safety covers
• Refi tting the safety covers requires some practice. Moreover, it is important to do this correctly,
because they are an extremely important part of the safety provisions on your machine, and
these covers protect you against possible danger.
• Always handle the safety covers carefully in order to prevent damage to the covers or the
machine.
• Always use the two handles when moving the safety cover. This enables you to fi rmly grasp the
safety cover and position it more easily.
During refi tting, take account of the following points:
1. Move the safety cover towards the machine until it is approximately 5 cm above the actual
position of the machine.
2. At the side of the belt drive, make sure that the safety cover fi ts underneath the belt guides.
3. Push the safety cover slightly towards the front of the machine, so that the edge of the cover
hooks onto the rear of the chassis.
4. Then allow the cover to rest completely on the chassis of the machine and press gently on the
round part of the cover until it is fi rmly seated on the chassis.
5. Check whether the safety cover is fi rmly seated on the chassis at the following locations:
1. Check the groove between the feed hopper and the safety cover.
2. Make sure that the safety cover is fi rmly seated against the wide edge of the chassis.
3. Check whether the gearbox is fi rmly sealed.
4. Check whether the safety cover at the top is pushed fully downwards.
5. Check whether the rubber seal between the radiator and the safety cover is fi rmly sealed.
6. Refi t the rubber boot bolts.