Eliet MA 018 010 130, Руководство пользователя

Страница: 44 / 69

44
English
11.3.3 Opening the shredding chamber
To gain access to the blades, there are two procedures to gain access to the shredding chamber:
- For a quick check of the blades or a minor intervention (read 11.3.4)
- Extensive maintenance to the blades (read 11.3.5)
Warning:
When you wish to inspect the condition of the blades or perform maintenance
on the blades, always fi rst switch OFF the engine and remove the key from the
ignition lock.
11.3.4 Quick check of the blades:
• Remove the discharge screw (read 11.3.1).
• Turn the small locking pin (on the rear of the machine) forwards until the pin protrudes.
• Two black locks are located on each side of the collector.
• Press your foot against the chassis and pull both handles backwards at the same time.
• Take into account that the collector weighs 40 kg.
• Turn the collector as a whole away from you around the hinge point.
• Turn the collector further upwards until this side takes into place behind the locking pin.
• Make sure that the locking pin protrudes completely so that the collector does not accidentally
swing closed.
• Now you can easily inspect the blades underneath.
• To reclose the shredding chamber, you simply remove the locking pin so that the collector
closes due to its own weight.
• Always check whether the collector is fi rmly secured by the two black clamps.
11.3.5 Extensive maintenance to the blades
• Remove both large safety covers at the side (read 11.3.2).
• Loosen the 3 M8 bolts (13 mm spanner) and then screw the cover on the shredding chamber
open around the central hinge.
• It may be necessary to use a crowbar to prise open the fi rst few centimetres of the cover.
• When prising open the cover, part of the bottom of the fl ap will come into contact with the
blades. Turn the rotor as required (turn the pulley) until you can fully open the cover.
• CAUTION : The cover weighs approximately 35 kg.