Eliet MA 018 010 130, Руководство пользователя

Страница: 42 / 69

42
English
11.3.1.3 Refi tting the discharge screw (same procedure for both versions):
The screw must be refi tted taking the following points into account:
• Ensure that both ends of the hinge pins are fully seated in the hinge support.
• Swing the discharge channel downwards.
• Check (extremely carefully) whether the conical end of the screw from the collector is correctly
connected to the screw in the discharge channel.
• When the screw starts to rotate, position the two parts so that the connection describes a spiral
line.
• Make sure that the safety switch is correctly depressed when the discharge channel presses
against the collector.
• Make sure that wood chippings or dirt are not present between the groove of the discharge
channel with the collector.
• Always lock in the correct manner.
• If the clamp is not tight enough, adjust it by screwing the tensioning pin further inwards.
11.3.2 Removing and fi tting the safety covers
Warning:
If you wish to remove the safety covers, always fi rst switch OFF the engine and
remove the key from the ignition lock.
11.3.2.1 Removing the large safety covers
Remove the bolts (1, 2, 3, 4) securing the motor hood.
• Each side of the hood is equipped with two handles that enable you to fi rmly grasp the hood.
• To remove the hood : fi rst gently lift it upwards until the safety cover at the top becomes
detached.
• Then move the cover away from the machine.
• Handle the safety covers with care and store them in a safe and isolated location during the
maintenance. Make sure that they do not fall over or become damaged. This would make it dif-
fi cult to refi t them.