10.4 Users manual for Wheeled Transportation Accessory /WTMD Wheeler
peration:
e
both(side
anels) on wheels by firmly holding, slowly ride your WTMD to the new place you want.
xing parts for the “Wheeled Transportation Accessory” is shown on this chart below.
ssembled, Wheeled Transportation Accessory for WTMD (all models).
sembly;
s (a) on the figure 1
e wheels) to be fixed at both ends of item
Item number (g) should be fixed at both ends.
O
This device is designed as an accessory for the WTMD Models(all) ThruScan s3/s9/sX/sX-i/sX-
WP and for transportation purposes only. To use this accessory correctly, make sure that you hav
assembled the apparatus properly. The assembled WTMD should be carefully placed into the
transportation accessory and then the item number (h) should be used to fix the accessory by
screwing to the bottom part of the side panels.(Make sure that you are not screwing extremely
tight NOT TO CAUSE ANY DAMAGE ON THE PLASTIC SIDE PANELS) After getting on the WTMD on
the “Wheeled Transportation Accessory”, carefully lay down the WTMD then hold up the
p
Figure 1
Fi
Figure 2
A
As
1- Place item number (b) between pieces shown a
2- Item number (c) to be fixed through the hole.
3- Items numbered (d) to be fixed at both ends of the item number (c)
4- Place item number (f) through item number (e-th
number (c) as shown on the Figure 1 and Figure 2
5-
*To unassemble; the steps described above should be followed in reverse.
48
