4.1.6.2
FOR;
ThruScan
s9/sX/sX-i/sX –WP
ThruScan
has a traffic counter monitoring both incoming and outgoing traffic through WTMD thus
indicates the number of persons passing through the unit in both directions after the last memory
“reset”.
.
The IN&OUT counter values are displayed on the LCD (screen) and one can compare the difference
between the two counters to find the number of persons still in the building.
The traffic counter memory can be viewed or reset as follows:
1.
Press
UP&DOWN
buttons until the
IN<COUNTER>OUT
COUNTER sub-
MENU option is displayed,
2.
Counter value stored in the memory will be displayed for both
the IN & OUT counters separately,
3.
To reset the counters press
SEL(
√
)
button to enter the reset
MENU,
4.
Select either
00
(do not reset),
01
(reset the
IN count
),
02
(reset the
OUT count
) or
03
(reset
BOTH COUNTERS
) by
UP&DOWN
buttons,
5.
Press
SEL(
√
)
button to select and fix the setting.
Press
UP&DOWN
buttons to move to the next
sub
-MENU option or press
RUN(X)
button to store
the changes and thus return to the normal operating mode.
NOTE: Please ask the alarmed people to walk back through the WTMD so that the in &
out counters wouldn’t count the same person again and again. This way, the number or
the people inside would be accurate.
Continuous operation & detection can be obtained when IR Pass Sensor LEDs are
obstructed.
4.1.7 FACTORY SETTINGS
ThruScan
can be returned to factory settings as follows:
1.
Press
UP&DOWN
buttons from the MENU until the
FACTORY SETTING
sub
-
MENU option is displayed.
2.
To reset return to factory settings press
SEL(
√
)
button to
enter the factory reset MENU.
3.
Use
UP&DOWN
buttons to select
Y (YES)
or
N (NO)
.
4.
Press
SEL(
√
)
button to select and fix the setting.
NOTE: When reset to Factory defaults, this does not change
the in & out counters. Only such displays as the sensitivity adjustments, programs or
volume adjustments return to their factory settings. To change the in & out counter’s
values see Section 4.1.6
IN < COUNTER > OUT
00000 00000
IN < COUNTER > OUT
00000 00000
ACTIVE = 00
FACTORY SETTINGS
Y<==>N
FACTORY SETTINGS
Y<==>N
ACTIVE = N
Press
UP&DOWN
button to move to the next
sub
-MENU option or press
RUN(X)
button to store
the changes and thus return to the normal operating mode.
26
