Electrolux MAGISTAR OVEN 6-10-20GN, Руководство по обслуживанию, Страница: 67 / 124

67
D.4.4 Upload programming file and programming parameters
The Programming File and Programming Parameters (that from now on we will call P.F and P.P . as abbreviation) are the software
packages of the oven.
Only for DIGIT electronic boards the packages can be installed in the same way and at the same time/together.
IMPORTANT
• Update of software 1.0.2 and 1.0.7 (appliances made before week 39-2019 / 25 September 2019), into 1.1.0/1.1.2/
1.2.1/1.3.2 will erase some data!
• Recipes / alarm log / HACCP / Counters; personalizations of parameters & accessories will be erased. Were possible
this history data needs to be downloaded into a USB before update and then reloaded/reset/enabled into the updated
oven!!!
• Update of software 1.0.11 and 1.0.18 into 1.1.0/1.1.2 will NOT erase customer data (recipes / alarm log / HACCP
/ Counters) but will erase personalizations & accessories (these will need to be re-set/enabled after update)
.
WHEN TO UPDATE
• When ever you see an older version UI application software (refer to the identification at chapter D.4.2.10 Identity card (APPL
dAtA) .
• In case of any spare part replacement (UI or ACU).
HOW TO UPDATE
In the previous chapter D.4.3 Software update B, C (Digit) we have explained were to locate the P.F / P.P in the PRIDE / AGELUX
web site and how to unzip/save into your USB key in the root.
• Once that the USB key has been prepared in the correct manner and for the specific PNC appliance:
Turn OFF the oven. Insert the USB key with P.F. / P.P.
installed in root.
Turn OFF the oven.
The software will install automatically and update the UI and ACU electronic boards.
• At the end of installation the display will show a blinking message “turn OFF“.
• To complete the installation, turn off the oven, extract USB key, turn back ON the oven.
IMPORTANT
• In case of power loss during installation, in case of extraction of the USB key during installation or other manoeuvring
error don't worry, start again the update process the process can be restarted again.
• In case of errors or problems with the detection of the USB key, upload the software into another type of USB key
(manufacturer/dimension size) it could be that some USB key manufacturers cannot be read by the oven.
D.4.5 Accessories, Enable in parameters
NOTE!
IN THE ACCESSORY PACKAGING BOX IS CONTAINED A DEDICATED MANUAL WITH DETAILED EXPLAN-
ATION. A QR-CODE IS ALSO AVAILABLE TO ACCESS A WEB MANUAL.
If any accessories are added to an oven, it may be necessary to enable the item: first it will be necessary to enter into the parameter
list and “add in/enable“ the parameter, EXAMPLE: Lets say we need to add the accessory HOOD, enter in Service/parameters and
enable/disable and/or adjust par 347.
Parameter ID Mnemonic Short Description Long Description Table
347 Hood Select the hood level
installed Select the hood level installed {0, "Not installed”}
{1, “Level 1”}
{2, “Level 2”}
{3, “Level 3”}
{4, “Level 4”}
Once that the accessory has been added in the parameter list, the oven, will start to check and detect the accessory.
OTHER AVAILABLE ACCESSORIES:
• External connection kit for liquid detergent/rinse aid.
• Grease collection kit for oven base.