Electrolux EWFLW65H - 27'' Front-Load Washer, Техническое и сервисное руководство

Страница: 68 / 92

4-6
Component Teardown
Door Lock Assembly Removal
The door lock assembly is secured with two screws
to the front of the unit frame. The wire harness is
attached to backside of the door lock assembly.
To remove the door lock assembly:
1. Using a #2 square bit screwdriver, remove 2
short course-thread, panhead screws from the
door lock. (See Figure 4-13)
2. Slide the lock toward the outer edge of the
front panel. Pivot the lock slightly outward
while slowly pulling it through opening to
expose the attached harness.
(See Figure 4-14)
3. Release the harness from the terminal with
the small lever on back of the lock. Separate
the harness from the lock, allowing the
harness to lay outside the front panel.
(See Figure 4-15)
Bellows Removal
The bellows or boot gasket provides a seal for the
washing compartment and a mounting cavity for
the interior light and the Advanced Rinse
Technology (ART)hose. A spring loop retains the
bellows to the front panel of the washer and to the
inner wash tub. The bellows must be released from
the front panel before removing the front panel to
access the spring loop on the wash tub.
To remove the bellows:
1. Remove the door.
2. Pull back the top section of the bellows at the
top of the wash compartment opening.
3. Extract the LED light assembly from the
bellows.
4. Using a pliers, remove the ART hose from the
left underside of the detergent dispenser.
5. Using a needlenose pliers, pull the spring loop
out from the retaining lip of the bellows.
(See Figure 4-16)
6. Pull the front of the bellows off the lip of the
front panel to release it.
7. Remove the bellows by placing your hand
under the bellows at the top of the opening
and lift up while pulling out. A second spring
loop secures the bellows to the wash tub.
Figure 4-13.
Figure 4-14.
Figure 4-15.
Figure 4-16.
Spring
Loop
Bellows