Electrolux EWFLW65H - 27'' Front-Load Washer, Техническое и сервисное руководство

Страница: 28 / 92

Installation Information
2-12
Reversing Door
Preparing to Reverse Door Swing
1. Be sure you have adequate swing area before
reversing door.
2. You will need a screw driver with a #2 square
bit.
3. Protect flat work surface, such as top of
washer or floor near washer, with a soft cloth
or towel.
4. Be sure washer is unplugged from power
source.
Removing Trim Ring
1. Open the door to a 90 degree angle.
2. Remove and save the trim plug and long,
course-thread, panhead screw.
(See Figure 2-8)
3. Close the door.
4. Rotate the door trim approximately ¾”
counter-clockwise and pull it away from the
front of the door. (See Figure 2-9)
Removing Door from Hinge
1. Reopen door to 90 degree angle.
2. Remove 4 long, course-thread, counter-sunk
hinge screws from door. (See Figure 2-10)
3. While supporting the weight of the door with
both hands, separate the door from the hinge.
(See Figure 2-11)
4. Gently place the door face down on a flat,
covered work surface.
Figure 2-8.
Figure 2-9.
Figure 2-10.
Figure 2-11.