Electrolux EWFLW65H - 27'' Front-Load Washer, Техническое и сервисное руководство

Страница: 77 / 92

4-15
Component Teardown
Detergent Cavity Assembly Removal
The detergent cavity assembly is secured to the top
brace with two screws and is supported by a tab
that slides under a lip formed on the assembly.
The assembly is also secured to the control
console with two screws behind the detergent
drawer.
To remove the detergent cavity dispenser:
1. Remove detergent drawer.
2. Using a #2 square bit screwdriver, extract
the two screws securing the detergent cavity
dispenser to the console. (See Figure 4-38)
3. Remove top panel.
4. Remove water inlet valve assembly and
over flow/vent tube.
5. Using a #2 square bit screwdriver,
disconnect detergent dispenser outlet hose.
(See Figure 4-41)
6. Extract the two screws securing the detergent
cavity dispenser to the center brace.
(See Figure 4-39)
7. Release the (2) retaining latches, one on each
side, locking the housing to the console
mounting panel. (See Figure 4-39)
8. Slide the housing back until the tab of the
top center brace release and the housing
drops down. (See Figure 4-39)
9. Using a pliers, disconnect the advanced
rinsing technology hose. (See Figure 4-40)
10. Push down on the tub and swing the front of
the housing toward the center of the washer.
Work the housing out from under the center
brace and lift the housing out.
Detergent Dispenser Outlet Hose Removal
The detergent dispenser outlet hose is secured to
the bottom of the detergent dispenser and to the
side of the wash tub with hose clamps.
To remove the detergent dispenser outlet hose:
1. Remove the top panel.
2. Release the overflow/vent tube and slide it
back.
3. Using a #2 square bit screwdriver, loosen
the (2) clamps, one on each end, and slide the
hose off. (See Figure 4-41)
Figure 4-38.
Figure 4-39.
Figure 4-41.
Screws
Tab
Retaining
Latches
Screws
Hose Clamps
Figure 4-40.
Front Frame
AR
T Hose
To
Bello
ws
Hose Clamp
Bottom of
Detergent
Dispenser