Electrolux EWFLW65H - 27'' Front-Load Washer, Техническое и сервисное руководство

Страница: 21 / 92

Installation Information
2-5
Water Supply Requirements
Hot and cold water faucets MUST be installed with-
in 42 inches (107 cm) of the washer’s water inlet.
The faucets MUST be 3/4 inch (1.9 cm) with
threading for laundry hose connection. Water pres-
sure MUST be between 30 and 120 psi. Pressure
difference between hot and cold cannot be more
than 10 psi. The local water department can
advise the customer of the line water pressure.
Drain System Requirements
1. Drain capable of eliminating 17 gals (64.3 L)
per minute.
2. A standpipe diameter of 1-1/4 in. (3.18 cm)
minimum..
3. The standpipe height above the floor should
be: Minimum height: 24 in. (61 cm)
Maximum height: 96 in. (244 cm)
NOTE
Drain hose attached to the washer can reach
a 79 in. (201 cm) high standpipe. For higher
standpipe, use hose P/N 137098000.
Removing Foam Packaging
1. Temporarily remove door tape.
2. Open washer door and remove everything
from the drum.
3. Close door and reapply door tape.
4. Using a rug, blanket or piece of cardboard to
protect the floor, carefully lay washer on it’s
back.
5. Remove styrofoam base and shipping plug
and set them aside.
6. Carefully return washer to an upright position.
7. Carefully move the washer to within 4 feet
(1 m) of its final location.
IMPORTANT
Save styrofoam base and shipping plug for
use to help prevent washer damage during
any future moves.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than
one person move or lift the washer.
Figure 2-2. Standpipe Dimensions
Figure 2-3. Unpacking Unit