EKO MP-170, Руководство по эксплуатации

Страница: 21 / 55

20
4) Start Screen
After turning on the Main unit, see whether the Sensor unit is connected with the
Main unit through modular cable. The warning message “Powering on Sensor
Unit” will show if it is not connected with the modular cable or not communicating
through the modular cable.
5) The Message Screen for Indication of Power ON of the Sensor Unit
If the Sensor unit is not in use, press any key from this condition; the main menu
screen should be shown and be able to continue on the operation. If the Sensor
unit is used, connect the Sensor unit to the Main unit with modular cable; turn ON
the Sensor unit power after turning ON the Main unit power. The time is
synchronized automatically between the Sensor unit and the Main unit without
any warning messages and so on.
Go through this process for each use of the Sensor unit.
* If the time did not get synchronized, it may not be able to upload the data from
the Sensor unit or may upload the data, which the dates do not match with the
Main unit.
6-3. Main menu
1) Main menu
DATA : Go to data management menu
CONFIG : Go to parameter setting menu
MEASURE : Start measurement
NOTE : Give at least 1 minute interval for each
measurement)
Select menu by pressing these keys
2) Monitoring screen
Press Up/Down key from the main menu, the screen
goes to monitoring screen, which shows the date, time,
irradiance, module temp., temp.2, and Voc.
If the sensor unit is not connected, the irradiance and
temperature values will be shown with fixed values as
1000.00 W/ m², 25.0°C.
ＭＰ－１７０ ＭＰ－１７０ ＭＰ－１７０ ＭＰ－１７０
DATA CONFIG MEASURE
M P – 1 7 0
MONITOR
Voc: 589.00 V
TIME: 12:10:00
Module temp.: 25.0 °C
Irradiance:1000.00 W/m
²
²²
²
DATE: 2007/01/10
temp2: 25.0
°
° °
°
C