Eco ETS 64-R, Монтаж и эксплуатация

Страница: 27 / 112

ETS 64-R
0548-990-61---70g_2019.10.indd
B D C E A C E
B
B
A
C
C
A
58
1,5 1,5
650
50
400
4
≈ 22,5°
D
H I
E
25 Nm
0548-990/62g
Page 27 of 95
Mounting and operating instructions
Drive mechanism standard
6. Close the door leaf .
7. Prior to the installation of the drive unit:
Screw down the lever arm (D) on the drive unit

Tightening moment 25 Nm.
Attention:
The pre-stressing of the lever arm (D) depends on the
existing lintel depth.
Example: Lintel depth 0 mm, pre-stressing of the lever
arm (D) ≈ 22,5° (1 grid increment of the output shaft
= 15°).
Note:
To facilitate the installation, the closing spring (H)
can be completely released by means of the setting
screw (I).
8. While mounting the drive unit, push the lever arm (D)
back by the pre-stressing angle of 20°.
9. Slide the open position stop piece (B) into the sliding
rail (C).
10. Slide the sliding rail (C) over the glider (E) and bolt it
onto the door leaf.
11. Screw down the open position stop piece (B) approx.
5° before the door leaf reaches the maximum open
position.
12. Insert the covering caps (A) on both sides.

forward to chapter 4.6
Inverse application
6. Mount the drive mechanism.
7. Open the door leaf (max. 115°).
8. Slide the open position stop piece (B) into the sliding
rail (C).
9. Slide the sliding rail (C) over the glider (E) and bolt it
onto the door leaf.
10. At the complete door opening (max. 115°):
Screw down the lever arm (D) on the drive unit

Tightening moment 25 Nm.
11. Screw down the open position stop piece (B) approx.
5° before the door leaf reaches the maximum open
position.
12. Insert the covering caps (A) on both sides.
 back to page 24
Attention:
Check the motional sequence of the door leaf: The rods must not touch!
If the glider (E) makes screeching noises, it needs to be lubricated wih a little WD40.