Eco ETS 64-R, Монтаж и эксплуатация

Страница: 39 / 112

ETS 64-R
0548-990-61---70g_2019.10.indd
EN 3 EN 4 EN 5 EN 6
950 mm 1'100 mm 1'250 mm 1'400 mm
18 Nm 26 Nm 37 Nm 54 Nm
- 27 mm 23 mm 17 mm
27 mm 22 mm 14 mm -
26 mm 22 mm 17 mm 9 mm
X*
0548-990/62g
Page 39 of 95
Mounting and operating instructions
Closing spring
Adjusting screw
EN class
Width of door leaf
Closing torque 0...4°
Normal rods
Measure X *
Sliding rods pulling function
Measure X *
Sliding rods pushing function
Measure X *
4.6 Adjusting the pre-stressing of the closing spring
Upon delivery, the closing spring is pre-stressed for a measure X* = 26 mm. To ensure a safe and
optimal operation of the swing door drive mechanism, the correct pre-stressing must be adjusted
for the closing spring (by means of the setting screw).
Note:
The correct pre-stressing of the closing spring must imperatively be adjusted before
carrying out the automatic setting-up procedure! The setting values are mandatory for
fire-protection and/or escape way doors.
Attention:
The setting screw needs to be shortened by 10 mm if it butts against the side cover's
strain relief (with program selector key).
Procedure:
1. Close the door leaf.
2. Using the setting screw, adjust the measure X* in function of the respective situation.
3. Open the door leaf by at least 60° and then let it be closed.
* Measure X is an approximated value for a lintel depth of 0 mm. The force necessary for manually opening a door must
not exceed 150 N. This effort shall be measured as a static force on the main closing edge (perpendicularly to the door
leaf), at a height of 1'000 mm ±10 mm.
Program selector
further away from
the door hinges
Drive mechanism standard
Strain relief
Adjusting screw