Ecco Xtatic HP6000, Руководство по эксплуатации и обслуживанию

Страница: 20 / 36

18
(2) If you want to suspend the work longer than 24 hours:
When using a two-component paint or other paint that cures by chemical action
or paint that settles easily, clean the gun with the following procedure after each
use.
1. Be sure to turn off the power switch on the controller.
2. Remove the suction pipe from the paint container.
3. Reduce the operating pressure of the paint pump to a low level and run the pump to discharge the
paint from the return side.
4. Trigger the gun to discharge the paint remaining in the hose and gun from the tip of the gun.
5. Suck the solvent through the suction pipe and discharge it from the return side. Repeat those steps
until the inside of the pump becomes clean.
6. Trigger the gun to discharge the solvent from the tip of the gun. Repeat those steps until the hose
and the inside of the gun become clean.
7. Reduce the operating pressure to 0MPa and stop the paint pump to release the pressure in the paint
circuit from the tip of the gun.
8. Thoroughly wipe off the paint mist and other contaminants deposited to the nozzle and barrel by means
of a cloth soaked with solvent. Detach the nozzle and remove the paint deposited to the gun and nozzle
seats.
9. Raise the wrap air pressure and slightly trigger the gun to release the wrap air only and remove the
solvent that has intruded into the air circuit.
10. Reduce the wrap air pressure to 0MPa again.
11. Lock the trigger to terminate operation.
There is a possibility of injury.

When suspending or finishing operation be sure to raise the slider at the trigger to
lock the trigger. If you fail to do so, the gun may be accidentally triggered.
①
Air wrap airless electrostatic spray gun
(1) Keep the air wrap airless electrostatic spray gun clean. When cleaning the gun, do not immerse it into a
solvent but carefully wipe out using a bristle brush or cloth soaked with a small amount of solvent while
holding the gun with hand.
There is a possibility of injury, electric shock or fire.
Before cleaning, be sure to check that the power switch on the controller has
been turned off for 10 seconds or longer. Then, reduce the pressure according to
the pressure releasing procedure (on page 3).
Never immerse the air wrap airless electrostatic spray gun in paint thinner.
Doing so will significantly reduce the service life of the gun.
(2) Do not disassemble the gun parts other than specified. If the gun gets out or order, please contact us.
(3) When not using the gun, hang it on a dedicated gun hook.
CAUTION
WARNING
Maintenance
6
WARNING
CAUTION