Ecco Xtatic HP6000, Руководство по эксплуатации и обслуживанию

Страница: 26 / 36

24
Parts replacement and repairing shall be conducted according to the procedures below. During the
procedure, be sure to stop the compressed air supply to the gun, turn off the control unit, remove the paint in
the paint circuit and clean the circuit. (The numbers shown below correspond to the numbers or part
numbers in 10
“Exploded Diagram and Names of Parts.”)
①
Replacement of paint seats
Remove the paint seats 33 (6004 0335 43) at the end of the barrel using a box screwdriver. They shall
be installed and removed with the gun triggered. This operation requires a Hex. 10 box screwdriver.
If the front seat has been damaged, replace it with a new one.
②
Replacement of paint filter
(1) Remove the paint hose and loosen the nut 10 (6004 0335 77) that is securing the stay 8 (6004 0335
76). Then, remove the retainer 38 (6004 0335 83).
(2) Rotate the retainer and take out the filter 36 (6004 0335 70). If it is stuck and cannot be easily removed,
push it from the opposite side using a pin or the like.
9
Parts Replacement Procedure and Adjustments