Ecco Xtatic HP6000, Руководство по эксплуатации и обслуживанию

Страница: 15 / 36

13
⑥
Caution in bundling and handling the connecting cable
(1) When bundling the electrostatic spray gun connecting cable and hoses, follow the instructions below, in
order not to impair the strength and service life of the connecting cable.
①
Do not bundle the connecting cable and hoses at points within about 70cm from the electrostatic
spray gun.
②
When bundling, leave a slack in the connecting cable relative to the air and paint hoses so that the
connecting cable will not be bent at an acute angle or tensed when the electrostatic gun is directed
to the top, bottom, right or left.
③
Bundle the cable and hoses at intervals of 5cm, starting at the point 70cm apart from the grip of the
electrostatic spray gun, using resin bands (insulation locks) or plastic tapes with some slack left in
the cable. Do not continuously wind a plastic tape or wider spiral tube around them. The wound part
of them become rigid like a stick and both ends of this part may be bent to cut or damage the
connecting cable and/or hoses.
(2) During a spraying operation, do not operate the electrostatic spray gun or bundle the connecting cable
and hoses in such a manner that bends at an acute angle or excessively tenses the connecting cable
and air and paint hoses. Doing so reduces their strength and may cut them.
(3) Take enough care not to step on the connecting cable. Stepping on it over a metallic drain board may
cut wires in it by the board.
(4) Do not continuously wind a plastic tape or the like around the connecting cable alone (especially around
the electrostatic spray gun connector) to reinforce the cable or prevent contamination. Doing this rather
reduces its strength and may cut wires in it.
(5) Do not immerse the connecting cable in a solvent or paint for a long time.
Doing so significantly impairs its strength and service life.
(6) After cleaning the connecting cable, be sure to wipe off the solvent deposited to its surface or blow it off.
(7) Do not use metallic bands. The static electricity may be accumulated in them to give you a smarting
pain.
CAUTION
Paint hose
Air hose (black)
Connecting cable
When bundling, leave more slack in the
connecting cable than in air and paint hoses so
that the connecting cable will not be severely
tensed when the gun is directed upward or
downward.
Bundle at intervals of 50cm or more after the
point 70cm apart from the gun.
Approx. 70 cm