4
Danger of the misuse
<<General safety notes>>
An excessive pressure, modifications to the parts, the misuse of the paint or solvent or the use of a
worn or broken part may lead to damage to the pump, injury from the paint spray or splashes into
your eyes or skin and/or serious disasters such as fire and explosion.
Never replace or modify any part of the air wrap airless electrostatic spray gun or coating machine
without permit as doing so may lead to a malfunction or injury.
Periodically inspect the whole machine and repair it or replace defective parts as necessary.
Contaminants on the barrel of the gun may generate electrostatic sparks, possibly resulting in fire.
Periodically clean the barrel and keep it free from paint and deposited matters.
Electrostatic sparks may catch fire during the treatment of the machine.
When cleaning the gun or nozzle with a solvent or removing a part, always turn off the controller
and, five seconds after that, bring the corona pin at the tip of the gun into contact with the
grounding wire, or any grounded metallic object for 10 seconds or longer.
When servicing the product, do not remove any part other than specified.
If a problem such as a crack in the barrel or another insulating parts or a flaw on the connecting
cable is found during the inspection, withdraw the product from service and immediately contact
the distributor or us for replacement of the defective part.
When stopping or finishing the spraying operation, turn the controller off.
Some substances contained in the paint or solvent do harm if inhaled or contacted to your skin.
Observe the instructions in the Material Safety Data Sheets provided by the paint and solvent
manufacturers.
Install an adequate ventilation system to prevent accumulation of hazardous substances.
When performing a spraying operation, always wear the safety goggles, working clothes and mask
recommended by the paint and solvent manufacturers. Special protective devices may be
required depending on the paint type or ventilation. Please consult the paint and solvent
manufacturers.
<<Machine internal pressure>>
The maximum operating paint pressure in the air wrap airless electrostatic spray gun is 21MPa.
Never apply the pressure above this level. Take care when setting the pressure of the paint
pressure-feed pump. For the nozzle, use a high-pressure type with a protrusion on the seat at the
backside of the chip. Check that all components of the machine and its accessories such as hose,
connectors and swivel withstand the maximum operating pressure specified above.
If the withstanding pressure of a component or accessory of the machine is lower than the
maximum operating pressure of the pump, take care
not to exceed the maximum operating
pressure specified for that component or accessory.
Before using the machine,
fasten all connections
.
WARNING
Содержание Xtatic HP6000
Страница 32: ...30 ECCO Xtatic HP6000 Exploded Diagram ...
