EC POWER XRGI 6, Инструкция по обслуживанию, Страница: 9 / 50

MAINTENANCE
Only perform maintenance work on the XRGI ® system when it is not in
operation and is fully cooled down! Otherwise, there is a risk of burns from
hot components and/or scalding if substances should escape.
REQUIRED MATERIAL
EC POWER service kit for XRGI
® 6 ( Item No.: 01KIT2611 ) consisting of:

1 pc. exhaust gas compensator

1 pc. vacuum sensor

2 pcs. hose clamps

1 pc. vacuum filter

1 pc. air filter

1 pc. gasket valve cover

4 pcs. engine oil

3 pcs. spark plugs

2 pcs. zero pressure hose Ø2,0x1,5

1 pc. oil filter

1 pc. plug for measuring point
REQUIRED TOOLS

Engine oil suction pump

16 mm spark plug wrench

Oil filter spanner

17 mm socket insert

Torque wrench

10 mm socket insert

Water pump pliers

3 mm Allen screwdriver

Hose clamp pliers

5 mm Allen screwdriver

Funnel

10 mm ring spanner

Feeler gauge

24 mm ring spanner

FS2009USB programming device

10 mm open-ended spanner

Flue gas analyser

17 mm open-ended spanner

19 mm open-ended spanner

10 mm socket spanner
Before commencing maintenance work, shut down the XRGI ® system at
the user level on the iQ-Control Panel and at the main switch. Close the
gas valve and unplug the Q-Heat Distributor.
4. MAINTENANCE XRGI
®
6
Fig. 4.01
8