EC POWER XRGI 6, Инструкция по обслуживанию, Страница: 5 / 50

13. Never wet-clean the XRGI
®
system. Never use solvents, turpentine, petrol, abrasive cleaning agents or similar
on the XRGI
®
system. Before re-commissioning the machine, ensure all parts have properly dried out.
14. Only allow specially educated technical personnel authorised by EC POWER to perform repairs on the system.
15. Only allow trained technical personnel to remove the housing of the XRGI ® system.
16. If any safety equipment has to be removed/disabled to make working on the XRGI
®
system possible, make
sure that the safety equipment is installed/enabled again before restarting the XRGI
®
system.
17. Never start the XRGI
®
system with missing or damaged safety equipment. In case of missing or damaged
safety equipment turn off the master switch and repair or replace the safety equipment immediately.
Handling engine oil
Always wear protective gloves and safety glasses when handling engine lubricants!
In the event of contact with engine oil:
18. Property:
Use absorbent material to wipe off and dispose of as hazardous waste. Replace clothing and shoes contaminated with oil.
Do not put any oily rags and/or cloths in your pockets.
19. Skin:
Wash off with water and soap or special hand-cleaning agents, where necessary, use a nail brush.
Do not use petrol, solvents or other similar fluids as cleaning agents. Apply a rich skin cream after washing and cleaning.
20. Eyes:
Thoroughly rinse your eye with lots of water and seek medical advice.
1.3 ELECTRICAL SAFETY INSTRUCTIONS
Danger of fatal injury when working on electrical and electronic components. Only allow specially educated electricians to perform work on
electrical or electronic components in accordance with current, applicable electrical regulations.
1.4 SAFETY EQUIPMENT ON THE XRGI® SYSTEM
The XRGI
®
system is equipped with a number of different safety devices that ensure its safe operation.
The safety equipment includes:
21. Master switch
22. Sound insulation panels (all casing panels)
Master switch on the iQ-Control Panel Sound insulation cladding on the Power Unit
Ensure that the warning labels (stickers) affixed to the XRGI ® system are always clearly visible, undamaged and complete. Replace
damaged or dirty warning signs. The warning signs can be obtained from EC POWER.
Fig. 1.01
Fig. 1.02
4