EC POWER XRGI 6, Инструкция по обслуживанию

Страница: 37 / 50

MAINTENANCE
Fig. 7.01
Only perform maintenance work on the XRGI ® system when it is not in
operation and is fully cooled down! Otherwise, there is a risk of burns from
hot components and/or scalding if substances should escape.
REQUIRED MATERIAL
EC POWER service kit for XRGI
® 20 (Item No.: 01KIT2583 ) consisting of:

1 pc. exhaust gas compensator

5 pcs. engine oil

2 pcs. hose clamps Ø47

1 pc. zero pressure hose Ø2,0x1,5

1 pc. hose clamps Ø21

1 pc. plug for measuring point

1 pc. foam gasket

1 pc. vacuum sensor

1 pc. injector

1 pc. vacuum filter

1 pc. lambda sensor

4 pcs. spark plugs

1 pc. air filter

1 pc. oil filter
EXTRA

1 pc. Power Wrap

1 pc. Rubber plug
REQUIRED TOOLS

Oil suction pump

Flue gas analyser

Oil filter spanner

Lambda sensor top long ½

Torque wrench

Retaining ring pliers

Water pump pliers

20.8 mm spark plug wrench

Hose clamp pliers

17 mm socket insert

Funnel

3 mm Allen screwdriver

Feeler gauge

5 mm Allen screwdriver

FS2009USB programming device

17 mm open-ended spanner
Before commencing maintenance work, shut down the XRGI ® system at
the user level on the iQ-Control Panel and at the main switch. Close the
gas valve and unplug the Q-Heat Distributor.
7. MAINTENANCE XRGI® 20
36