EC POWER XRGI 6, Инструкция по обслуживанию

Страница: 16 / 50

MAINTENANCE

Move the cursor to Send by using the ▲▼ buttons and press OK on the
user interface. The communication system will be initialised.
FOR SOFTWARE RELEASE 1.14.6 (OR HIGHER) ONLY!
If it is not possible to make a manual modem call, please note all settings
and operating parameters of the XRGI
®
system before the software update
on the form REQUEST DATA MODIFICATION and send the form to the
EC POWER customer service (support@ecpower.dk).
The submitted data will be transferred to the XRGI
®
system after verifica-
tion by EC POWER.
The connection is being established. All data have been received. The connection is being established.
STEP 3 – NETWORK CABLES
Disconnect the network communication to avoid any interference between the
XRGI
® system components.

Remove all network cables between the Power Unit, iQ-Control Panel and
Q-Heat Distributor and cover all unused RJ45 plugs with RJ45 ISDN net-
work terminators.
iQ-Control Panel Power Unit Q-Heat Distributor
STEP 4 – SOFTWARE UPDATE XRGI® SYSTEM
Software update of the XRGI ® system requires that the boards of all XRGI ®
components must be updated, otherwise the XRGI ® system may malfunc-
tion.

Update the heat control
PCB
of the Q-Heat Distributor, the central control
PCB
of the iQ-Control Panel and the ECU
PCB
or the gas safety
PCB
of the
Power Unit.
Use the FS2009USB programming device.
The ECU PCB has to be updated at 3 places (in priority order: J12, J19
and J20), the heat control PCB (Q40/Q50/Q60) at 2 places (J3 Heat
Control UART and J1 Heat Control) and all other PCB’s at 1 place.
STEP 5 – SOFTWARE UPDATE Q-NETWORK MODULES

After completing the software update of the XRGI ® system, remove all RJ45
terminators and reconnect all network cables.

Update all b
PCB’
s of the Q-Network modules connected to the XRGI
®
sys-
tem.
Please note that Q-Network modules run on PoE sorce (Power over Ether-
net). Thus, after updating the Q-Heat Distributor, restore the network con-
nections in order to update the Q-Network modules such as Storage Con-
trol and Flow Control.
Fig. 4.53 Fig. 4.54 Fig. 4.55
Fig. 4.56
Q-Network modules

Flow Control

VPP Gateway

Boiler Control

Modbus Gateway

Storage Control

Load Sharer S

Flow Master Control

Electric Heater Control

Aux Temp Tracker
Fig. 4.57
Fig. 4.48
Fig. 4.49 Fig. 4.50 Fig. 4.51
Fig. 4.52
15