MAINTENANCE
Push the oil separator hose onto the valve cover.
STEP 9 – EXHAUST GAS COMPENSATOR & HOSE CLAMPS
Loosen the hose clamps on the exhaust gas compensator by a hose clamp
pliers and put them aside.
Remove the exhaust gas compensator together with the two hose clamps
from both ends of the pipe.
Replace the exhaust gas compensator including the two hose clamps and
fix the exhaust gas compensator with the 2 hose clamps by a hose clamp
pliers.
STEP 10 – OIL
Add oil to the engine. Fill a maximum of
40 litres
of oil through the filler neck.
Use a funnel to fill the engine.
Check the oil level on the dipstick to ensure that the engine is not overfilled.
To do this, briefly screw on the oil cover and then take it off again.
After checking the oil level, fasten the oil cap by a water pump pliers.
Fig. 4.35
Fig. 4.36
Fig. 4.37
Fig. 4.38
Fig. 4.39
Fig. 4.40
13
