27-11-2014 54 ebode IPV4NVR
Note: Initializing the HDD will erase all the data saved on it, please backup the data
before formatting hard disk if necessary.
Disk Saturation:When the disk is saturated, you can choose to stop recording or
cycle coverage.
Pre-record Time:The time you set to record before the event. For example, when an
alarm triggered the recording at 11:00, if you set the pre-record time as 5 seconds,
the camera records it at 10:59:55.
Step3: Click Save button to take effect.
Storage Location
You can configure the storage location for snap picture and backup recordfile.
Choose “
(Parameter Configuration) > Device Management > Storage Location”. The
Storage Location page is displayed.
Snapshot Pictures To: Click the icon (Take Snapshot) in the Realtime Preview page or
Playback page, the snapshot picture will be saved to the Snap Picture Path in the local
computer.
7.4.3 Service Configuration
Motion Detection
Follow the steps to set the motion detection parameters. In the live view mode, once a
motion detection event takes place, the NVR can analyze it and perform many actions to
handle it. Enable motion detection function can trigger certain channels to start
recording, or trigger full screen monitoring, output alarm, send Email, upload FTP,
buzzer alarm and so on.
In the live view mode, there are icons at the right bottom of the screen for each
channel.
Icon indicates alarming but not recording, when motion detection was triggered.
Icon indicates recording and alarming, when motion detection was triggered.
You can follow the steps to schedule a record which triggered by the detected motion.
Choose ”
(Parameter Configuration) > Service Configuration > Motion Detection”.
The Motion Detection page is displayed.
