27-11-2014 5 ebode IPV4NVR
Installation Environment
Ensure device is installed in the well-ventilated, dust-free environment.
It is recommended to use a voltage stabilizer for supply of power. If the power supply
was unmatched, the device might work abnormally or stop working.
Check that the voltage of the extra power supply is the same with the NVR‘s
requirement, and the ground connection is working properly.
The distance between the NVR and other device or wall should be more than 6cm
away to facilitate heat dissipation.
Precautions
Please keep the device horizontally and avoid inclination or inversion.
Don’t touch the power switch with wet hand or damp items to avoid shock.
Do not splash liquid or metal filing on the NVR To avoid short-circuit fault or blaze.
The NVR does not contain any storage device. Please install a hard disk or connect to
storage device firstly. Otherwise, you cannot perform operations (recording / playback).
Please press power button to shut down the NVR instead cutting off the power
directly to avoid to damaged the storage device.
Do not take the device apart when it is operating(or connecting to power).
4. Overview
4.1 Product Introduction
The series of product series is a 4 channel embedded NVR. This advanced product series
receives a high quality video stream that is transmitted digitally by the IP Camera (IPC).
The product can perform live video preview, recording, playback, remote access, and
backup simultaneously.
4.2 Key Features
Network Monitoring
You can access the NVR system remotely through the browser on a PC or access the
NVR system locally by using the display or monitor.
Multi-Screen Preview
Multi-screen preview indicates that several pages are displayed on the screen of the
monitor based on the same scale. The NVR system supports single-screen and four-
screen preview.
Recording
The NVR supports recording and storing video files on a Hard Disk Drive(HDD). Stored
videos files can be queried or played back through Web or local GUI.
Recording can be classified into schedule recording, manual recording, and alarm
recording from low priority to high priority. The three types of recording cannot exist at
the same time. If recording of any two types is enabled at the same time, only the
recording of a higher priority takes effect.
Schedule Recording: Select the scheduled time segment to enable/disable recording.
Manual Recording: Manual enable recording in the corresponding channel.
Alarm Recording: Alarm recording is classified into motion detection recording.
Motion Detection Recording: After the motion detection function is enabled and
recording is selected, motion detection recording is enabled when motion detection is
triggered in the detection time segment and detection area.
Note: When NVR system time and IPC time are different, the NVR recording will based
on the NVR system time.
