MIRU S26PRO
EN
37
www.eberg.eu
7. TROUBLESHOOTING
Below are the possible symptoms and causes of minor faults and tips for solving them in the system:
Symptoms
»
Check for a possible cause
»
Tip to solve the problem
The device does not start up
»
Check correct power connection.
»
Connect the power cord plug to the power outlet correctly and securely.
»
Check that the display shows „Ft” - water tank full.
»
Perform manual drainage of the water collected in the tank (see section 5.4.).
»
Check the room temperature.
»
The operating temperature range of the device is 5 - 35°C.
The device works with lower efficiency
»
Check the cleanliness and patency of the air filter.
»
Clean and unblock the air filter.
»
Check that the airflow channels are not blocked.
»
Remove any obstacles blocking air flow.
»
Check that the windows and doors in the room are closed.
»
Close windows and doors in the room.
6.2. Servicing the refrigerant
Detailed rules of conduct and safety rules that must be strictly observed during all work with the
refrigerant are described in detail in chapter 2.2. Precautions when servicing the unit charged with R290
in this manual.
The basic rules of conduct are as follows:
1.
Gas / vapor is heavier than air. It may accumulate in confined spaces, especially at or below ground
level.
2.
Eliminate all possible sources of ignition.
3.
Use appropriate personal protective equipment (PPE).
4.
Evacuate unnecessary personnel, isolate and ventilate the room.
5.
Avoid contact with eyes, skin or clothes. Do not inhale vapors or gas.
6.
Prevent from reaching sewage system and public waters.
7.
Contain (contain) the source of the gas release (leak) if safe to do so. Consider using water spray to
disperse the fumes.
8.
Isolate the area until the gas is dispersed. Ventilate the room and perform a gas test before entering
the room. After the leak, contact the competent services (fire brigade).
Warning!
Do not touch the surface of the evaporator with bare hands as this may cause injury.
