Eberg AORI E25-09, Инструкция по эксплуатации

Страница: 55 / 76

AORI EN
55 www.eberg.eu
INSTALLATION DRAWING- INDOOR UNIT
STEP 1: SELECTION OF LOCATION
Installing the unit in the following places maycause malfunction. If it is unavoidable, please consult the local
dealer:
1. There should be noobstruction near air inlet and air outlet.
2. Choose a place where the condensation water can be dispersed easily and won’t affect other people.
3. Choose a place which is convenient to connect the outdoor unit and near the power socket.
4. Choose a place which is out of the reach of children.
5. The place should be ableto withstand the weight of indoor unit and won’t increase noise and vibration.
6. The appliance must be installed 2.5m above floor.
7. Don’t install the indoor unit right above the electric appliance.
8. Please try your best to keep way from fluorescent lamp.
STEP 2: INSTALL WALL-MOUNTING FRAME
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the level meter and then
point out the screw fixing holes on the wall .
2. Drill the screw fixing holes on the wall with impact drill (the specification of drill head should be the
same as the plastic expansion particle) and then fill the plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and then check if the frame
is firmly inatalled by pulling the frame. If the plastic expansion particle is loose, please drill another
fixing hole nearby.
STEP 3: OPEN PIPING HOLE
1. Choose the position of piping hole according to the direction of outlet pipe. The position of piping hole
should be a little lower than the wall-mounted frame, shown as below.
At least 15cm
At least 15cm
A
t least 250cm
At least 300cm
A
t least 15cm
Space to the wall
Space to the wall
Spac
e t
o the floor
Spac
e t
o the obstruc
tion
Spac
e t
o the c
eiling