Page 25
Chapter 4: Detectors/Devices Menu
This chapter explains the options in the Detector/Device menu.
Detectors
Program Zones
You can program (configure) each zone's behaviour at any time, whether or not a wired
detector is connected.
When you enter the menu, you will see the current configuration of Zone 0:
Use
or
to select the zone you wish to configure, then press
.
Note:
If a wired zone does not have a detector connected to it, make sure that its zone
type is Not Used (the default).
Name
You can give each zone a name of up to 40 characters. The control unit displays this
name when, for example, you select the zone or the zone generates an alarm.
Type
The list below shows the available zone types.
Note:
When configuring zone types, the display shows a “*” to the left of the zone’s
current type.
You can select a zone type quickly by entering the two-digit shortcut number shown
in brackets after
the type’s name in the list below. For example, enter “05” to select
Final Exit. The number does not appear on the display.
The abbreviation of the type name (e.g. HUA) appears in the top-right corner of the
display when you select a zone.
When several zones are activated at the same time, the control unit processes Hold
Up Alarm and Normal Alarm zones first, followed by Fire, and then all other alarm
types. The control unit always processes alarms before alerts.
Not Used - NU (00)
The alarm system will not respond when an event triggers this detector. This is the
default zone type for all zones.
This is the current "zone type". "NU" means "Not Used".
This is the zone number (0-9).
This is the current name of the zone.
