Eaton PRS0100001, Руководство пользователя

Страница: 27 / 43

Operating Instructions
27
Initial Checks
Be sure to make physical checks of the compressor to avoid serious failure before start-up.
12.
DO NOT
use air tools that are rated below the maximum rating of the compressor. Select air tools, air hoses,
pipes, valves, filters and other fittings accordingly.
DO NOT
exceed manufacturer’s rated safe operating
pressures for these items.
13. Make sure all hose connections are adequately secured to prevent tools or hose ends from being accidentally
disconnected.
14. Coolants and lubricants used in this compressor contain chemicals that can harmful or fatal. Take care to avoid
accidental ingestion and/or skin contact. In case of ingestion, seek medical treatment promptly. Wash with soap
and water after skin contact.
15. Antifreeze compound used in airline anti-icer systems contains methanol which is harmful or fatal if swallowed.
Avoid contact with the skin or eyes and avoid breathing the fumes. Wear goggles or a full face shield when
adding antifreeze compound to airline anti-icer systems.
•
If swallowed, induce vomiting and call a physician immediately.
• In case of eye contact, wash eyes with plenty of clean water for 15 minutes then contact eye
doctor immediately.
• Never store antifreeze compound in confined areas.
1. Make sure compressor is properly grounded and verify voltage is correct, especially when using a three phase
power.
2.
Double check internal control transformer before applying power to unit. Make sure wiring is correct to avoid
damage to circuitry and PLC. Refer to wiring diagram, figure 7.
3. Check for correct oil level. To avoid overfilling, check for correct oil level after machine has been stopped for at
least 10 minutes. If oil needs to be added, make sure all pressure is relieved before opening fill port. Use only
Eaton Compressor lubricating oil. Also make sure oil level does not drop below low level line on site glass during
operation. If it does, stop compressor immediately, let rest for 10 minutes, then add oil.
Air/Oil Separator tank is a pressurized component. To avoid serious
injury, be sure system pressure is relieved before removing fill plug.
Be aware oil temperature may be very hot. Use caution when opening
fill plug.
To avoid serious injury, keep all persons away from the discharge
opening of hoses or tools or other points of compressed air discharge.
If the machine is installed in an enclosed area, be sure to vent the relief
valve outside of the structure or to an unoccupied area.
WARNING
WARNING