3
Pow-R-Line X Retrofit Panelboards
Pow-R-Line X RetRofit PaneLboaRds
MN014011EN January 2020 eatoncanada.ca
Figure A: Mount Dead-front Cover to Chassis
Locating Interior Mounting Holes in Enclosure
In most instances the chassis should be centered in the
enclosure unless a special offset trim has been ordered.
Measure and draw vertical and horizontal centerlines.Using
these marks, support the interior in the enclosure and mark
the 4 holes that are located on the center axis.
See figure below.
Re-verify that all electrical conductors long enough to be
terminated properly.Ensure main incoming cables are long
enough to reach Main and Neutral termination locations
without compromising wire bending space requirements as
listed in the Appendix Table 3.
Ensure that electrical clearance requirements are
maintained per NEC
TM
/CEC
TM
.Care must be taken to ensure
that the trim will completely cover openings in
the enclosure.
If not using existing mounting hardware, mark minimum of
8 mounting locations, on the back of the enclosure. Drill and
tap 10-32 holes as per Fig. B
Figure B: Recommended Mounting Locations
Determine proper depth setting
To determine preset depth of the chassis, place a
non-conducting, insulated straight edge across the finished wall
surface and measure to the rear of the enclosure. See Fig.C
Figure C: Measuring Depth of Enclosure
Loosen qty. 8, 10-32 screws Fig. D installed at
the chassis corners.
Figure D: Depth Adjustment Bracket Screws
Set chassis depth by aligning bottom edge of interior
mounting rail with the appropriate depth as determined by
the measurement obtained inn the previous step. Torque
#10-32 screws to 24 in-lbs.
Install Interior
Install interior using mounting holes drilled and tapped in
previous steps using supplied 10-32 hardware.
Figure E: Verifying Depth of Mounting
Содержание P1RX 240Vac Max
Страница 2: ......
