8 SmartWire-DT
8.9 Programming
DS7 Soft starter
09/16 MN03901001Z-EN
www.eaton.com
173
8.9.3.5 Profiles 4, 5, 6: inputs (status)
Input bytes are mapped as follows on SmartWire-DT.
Profiles 4, 5, and 6 correspond to profiles 1 to 3, but with an added status
byte:
Profile 4 = Profile 1 (2 bytes) + DS7 status (1 byte)
Table 32: Profiles 4 to 6: input bytes
Byte
Bit
Designation
Meaning
0
0
Not used
1 - 7
section 8.9.3.2, “Inputs (status) pro
1
2
3
4
+1
(Status
DS7)
0
ERR
Error present
0: no error
1: Error
1
WARN
Warning present:
0: no warning
1: Warning
2
RDY
Ready, switched on:
0: not switched on
1: switched on
3
RUN
DS7 Run, power part active:
0: Stop (power section inactive)
1: Running (power section active)
4
TOR
Top of ramp:
0: Top of start ramp not reached
1: Top of start ramp reached
5
1)
CL
Current limit:
0: Current limit not reached
1: Current limit reached
6, 7
–
Not used
1) Bit 5 will only be activated if parameter 681.0 is set to 1.
Содержание DS7 Series
