Eaton DF6200, Инструкция по применению

Страница: 12 / 94

12
Amended: April 22
EMEA Fire Technical Support: DF6000/CF3000 Applications Guide
Zones
Assigning devices to the relevant zones can be done either at the panel direct or by using site
installer. The contractor should always provide the zone information, as this is part of the system
design process and takes into account the fire compartment boundaries.
The panel has 96 zonal led’s, if ringing patterns are required across a network then all zones must
exist on all panels within the network.
eg. Panel 1 has zones 1
–10 in use, Panel 2 zones 11 – 20 in use, Panel 3 zones 21 – 30 in use.
On Later version Site Installer 2.5.28.6 and Display and Loop Software dated later than 04/2011 zone
information is automatically transmitted across the network, so zonal cause and effect becomes much
easier to achieve.
Access Codes
There are three access codes for the DF6000
User Code: This allows control of the silence, evacuate and reset functions and also enable/disable;
replace device and check auto config functions. This code can be changed to a site-specific code.
Default Code: 2214
Engineer Code: This gives access to the engineer parts of the menu, which are used, for learning and
programming the system.
Default Code: 143243
Both of these codes are printed on a label on the inside of the panel door.
High Level Codes: This
codes give access to menu’s which:
•
Can be used to return the system to its factory settings, and to change the logos on the
display.
•
Disable ALL Outputs.
•
View all access codes and reset to default codes. (Changed on PH1 Display Software 3.3.51)
•
Display code minor revision shown in low left corner (PH1)
Default Code: 130170
Should the User Or Engineer codes be lost for any reason, please contact Fire Technical Support for
assistance.
User Menu Functions
Fig 4