Eaton DC1-S1011NB-A20CE1 1, Инструкция по установке и настройке параметров

Страница: 126 / 173

6 Parameter structure
6.2 Resetting Parameters (RESET)
122
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives 05/21 MN040058EN www.eaton.com
6.2 Resetting Parameters (RESET)
Table 30: Resetting parameters (RESET)
6.3 Extended parameter set
Table 31: Enabling and disabling access to the extended parameter set
Commands Description
Reset to default settings
+ +
Press the ▲ and ▼ and STOP buttons and hold them down for two seconds.
→ All parameters will be restored to their default settings.
The display will show
P-dEF
.
Resetting after a fault
Press the STOP button to reset a fault message.
The display will show
StoP
.
Commands Description
Enabling access to the extended parameter set
Press the OK button and hold it down for two seconds in
order to access the parameter interface
￫ The display will show the parameter that was last
used.
Use the ▲ and ▼ buttons to select parameter P-14
Press the OK button.
Use the ▲ and ▼ buttons to enter the password set with
P-37 (default setting: 101)
Press the OK button to confirm
￫ The extended parameter set (parameters > P-14 and
display values P00-…) will now be available.
Disabling access to the extended parameter set
Use the ▲ and ▼ buttons to set a value for P-14 that does
not match the password (P-37).
Press the OK button to confirm
￫ Only the “basic parameters“, P-01 to P-14, will be
accessible now.
￫
The extended parameter set (default setting for P-37 = 101)
contains parameters P-01 to P-55. Additional parameters P-60 to
P-68 can be configured for specific applications. The corres-
ponding password is 201 in parameter P-37 (value of P37 + 100).