![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-fd100/cutler-hammer-fd100_instructions-manual_3861073031.webp)
IM05805016K
Page 27
Effective October 2007
Manual Start Test
Place the controller in the 'MANUAL' mode by depressing the "MANUAL" button
- Fuel Solenoid relay will change state
Press the 'Crank #1' pushbutton
- The controller will attempt to crank off Battery #1
- When the engine starts "Engine Run" will illuminate
Press the "OFF" button to stop the engine
Once the engine stops, press the "MANUAL" button to return to 'MANUAL' mode
Press the 'Crank #2' pushbutton
- The controller will attempt to crank off Battery #2
- When the engine starts "Engine Run" will illuminate
Press the "OFF" button to stop the engine
Test Start Test
Place the controller in the 'TEST' mode by depressing the "TEST" button
- Drain Valve Solenoid will energize and reduce pressure
- controller will start automatically
- When the engine starts "Engine Run" will illuminate
Press the "OFF" button to stop the engine
Weekly Exerciser Test
Program the Weekly Timer to a time suitable to run the test
Place the controller in the 'AUTO' mode by depressing the "AUTO" button
- At the programmed date and time the drain valve solenoid will open and the pressure will drop
- The engine will run for a minimum of 30 minutes or for the duration of the RPT setting, whichever is greater
Reprogram the Weekly Timer for normal operation
Controller Function Tests
Overspeed
Place the controller in the 'AUTO' mode by depressing the "AUTO" button (Optional)
-Start the controller either by jumpering remote start (Terminal #11 & #28) or by dropping the pressure
-Press the 75% verify button on the speed switch in the engine control box, the engine should stop and the
controller should give an overspeed alarm
Press the "OFF" button to reset the alarms
Low Oil Pressure / High Engine Temp
Place the controller in the 'AUTO' mode by depressing the "AUTO" button
-Start the controller either by jumpering remote start (Terminal #11 & #28) or by dropping the pressure
-Place a jumper between Terminals #4 & #11, the 'Low Oil Pressure' light should illuminate
-Place a jumper between Terminals #5 & #11, the 'High Engine Termperature' light should illuminate
Press the "OFF" button to stop the engine