Page 28
Technical Documentation EASYRO
®
Water Treatment Systems© 2015 easymetal GmbH.
This information is subject to copyright laws and may not be reproduced or changed without express written permission of easymetal GmbH.
PREPARING THE SYSTEM FOR MAINTENANCE
1
2
3
Close the main water supply valve (1) and disconnect the power plug (2) of the EASYRO
®
from
the mains power supply.
If you use a membrane vessel, your water treatment system is under pressure. To release pressure,
you must turn the screw (3) of the filter housing with a screwdriver until the pressure can escape.
Main water supply valve
(Oventrop fitting)
Screw of filter housing
Model
Max. Output Amount
EASYRO
®
60/120
approx. 5 litres
EASYRO
®
240
approx. 10 litres
EASYRO
®
480
approx. 20 litres
4
Clean water outlet
Sewer outlet
Clean water
outlet to tank
Remove the clean water connection (4) from the
system. This is done by pressing on the holding
element to unlatch it and then pulling the tube
from the connector.
Then insert the tube included in the basic maintenance
kit into this outlet and place the end of the tube in
a bucket.
Please use a suitable collecting container according
to the following amounts.
