20
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
FIG. 17
FIG. 17
THREADING WELDING WIRE THROUGH THE SPOOL GUN
• Turn the ON/OFF Switch
[h]
on the Rear Panel to the
OFF
position and unplug the Welder from the power supply.
• Loosen the captive threaded knob retaining the Cover and remove it.
• Remove the Nut and Conical Spring that retains the Wire Spool.
• Place the Wire Spool on the Spindle with the wire feeding from the top and in a Counter-Clockwise direction.
• Install the Nut and Conical Spring with the large, open end toward Wire Spool. Tighten until it is nearly bottomed out on the wire spool.
• Cut off the small piece of the curved segment at the front of the welding wire and straighten the welding wire approximately 4” long.
• Loosen the Wire Tensioning Thumb Screw and feed the wire by hand from the Spool into the Idle Roller Assembly, through the Drive Roller Groove and
into the Inlet Wire Guide.
• Tighten the Wire Tensioning Thumb Screw slightly until it applies light-drag pressure onto the welding wire.
IMPORTANT NOTE:
If this is too tight it will deform the wire and cause feeding issues, if it is too loose the Drive Roller will slip on the wire.
• Install the Cover and fasten the threaded knob to retain it.
• Unthread the Nozzle and using the included Contact Tip Wrench
[hh]
Remove the Contact Tip from the end of the Spool Gun.
• Connect the Welder to a power supply and turn the ON/OFF Switch
[h]
on the Rear Panel to the
ON
position.
• Set the Welder to MIG mode and select the
ALUM
process in the User Menu for Spool Gun welding (see
MIG MODE USER INTERFACE OPERATION
).
• Depress the Spool Gun Trigger. Once the wire exits the end of the gun, turn the ON/OFF Switch
[h]
on the Rear Panel to the
OFF
position and unplug the
Welder from the power supply.
• Reinstall the Contact Tip and Nozzle. Cut the wire about 3/4” from the end of the Contact Tip.
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
This procedure requires that the Welder power be switched on. DO NOT make contact with the wire when the Spool Gun Trigger
is depressed.
Inlet Wire Guide
✓
Wire Spool
Wire Spool
Idle Roller Assembly
Cover
Cover Knob
Drive Roller
Wire Tensioning
Thumb Screw
Spindle
Wire
Spool Nut
and Spring
✓
✓
✓
✓
✓
✓
✓
Содержание MP200i
Страница 1: ...AC DC MP200i WELDER ASSEMBLY AND OPERATING INSTRUCTIONS Item 65375 ...
Страница 31: ...To order parts and supplies 800 343 9353 eastwood com 31 DATA CHART ...
Страница 38: ...38 Eastwood Technical Assistance 800 343 9353 tech eastwood com NOTES ...
Страница 39: ...To order parts and supplies 800 343 9353 eastwood com 39 NOTES ...
