Eastwood MP200i, Руководство по сборке и эксплуатации

Страница: 22 / 40

22
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
TIG WELDING SET-UP
The Eastwood Elite AC/DC MP200i is factory set-up for TIG Welding use with a 3/32”
Tungsten (included) and 100% Argon Shielding Gas (not included).
INSTALLING THE TIG TORCH
• Retrieve the Flex Head TIG Welding Torch
[J]
and thread the power/gas lead onto
the TIG Torch Power/Gas Connector
[c]
snugly
(FIG TIG DCEN)
.
• Plug the TIG Trigger Plug into the TIG Trigger and Foot Pedal Connector
[d]
at the
Front Panel and fasten the security lock
(FIG 7)
.
IMPORTANT NOTE:
The connection of the TIG Torch Hose/Wire Cable
[J] MUST
BE
fully threaded and snugged onto Gas/Power Connector
[c]
or gas may leak.
INSTALLING THE GROUND CABLE AND CLAMP
• Locate the Ground Clamp with 14.8’ [4.5m] Cable
[F]
and connect the plug on
the brass end to the Negative Ground Cable Connection ( - ) on the Welder
[f]
.
Align the key of the brass ferrule with the notch of the receptacle at the
12:00 position, insert the plug and twist Clockwise 1/2 turn until it is tight
(FIG TIG DCEN
).
INSTALLING THE FOOT PEDAL
• Unfasten the TIG Trigger Plug and unplug it from the Front Panel.
• Insert the Foot Pedal Plug and fasten the security lock.
TORCH DISASSEMBLY
• Make sure the Welder is turned off and unplugged.
• Remove the Back Cap from the Torch.
• If there is a tungsten installed in the Torch, pull it out from the front of the Torch.
• Slide the Collet out of the Torch rear.
• Unscrew and remove the Gas Nozzle.
• Unscrew and remove the Collet Body
(FIG 18) .
TORCH ASSEMBLY
• Select the Collet Body that matches your tungsten diameter and thread it back
into the front of the Torch.
• Select a Collet that matches your tungsten diameter size. Insert the tungsten into
the Collet and put the Collet and tungsten back into the Torch.
• The Gas Nozzle size should be selected according to shielding gas requirements
for the material being welded. This size can be referenced on the Suggested
Settings Chart. Select the correct Gas Nozzle and thread it onto the Collet Body.
• Reinstall the Back Cap to lock the tungsten in place. Always make sure the
tungsten protrudes 1/8” to 1/4” beyond the Gas Nozzle.
FIG. TIG DCEN FIG. TIG DCEN
FIG. 18 FIG. 18
Gas Collet Collet Back
Nozzle Body Cap
Tungsten
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
Turn the ON/OFF Switch [h] on the Rear Panel to the OFF position
and unplug the Welder from the power supply before beginning
welder set-up.