8
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
HOT METAL AND TOOLS WILL BURN!!
• Electric welding heats metal and tools to temperatures that will cause severe burns!
• Use protective, heat resistant gloves and clothing when using Eastwood or any other welding equipment. Never touch welded work
surface, the welding torch tip, nozzle or tungsten until they have completely cooled.
FLYING METAL CHIPS CAN CAUSE INJURY!
• Grinding and sanding will eject metal chips, dust, debris, and sparks at high velocity. To prevent eye injury wear approved safety
glasses.
• Wear an OSHA-approved respirator when grinding or sanding.
• Read all manuals included with specific grinders, sanders or other power tools used before and after the welding process.
Be aware of all power tool safety warnings.
INJURY HAZARD!
• Pull and guide Welder by the top Handle only.
DO NOT
pull on welder cables, hoses or wires to move Welder.
• Use caution not to trip on welder cables, hoses or wires when in use for welding.
• The Welder is intended for use with up to two 7” diameter cylinders. Use caution when handling compressed gas cylinders and
always keep in the upright position.
•
ALWAYS
properly secure welding gas cylinders in place with the supplied chains.
• This Welder is designed to accommodate specified welding gas cylinders only.
•
DO NOT
lift the Welder by the top Handle. Doing so may result in failure of the Handle mounting points which can allow the Welder
to fall causing severe injury!
•
DO NOT
exceed the rated 450 lbs. [205kg] weight capacity.
•
DO NOT
use as a seat.
•
DO NOT
stand or step on the Welder.
• Use on a flat and level surface only.
DO NOT
use on sloped surfaces.
DO NOT LIFT WELDER WITH CYLINDERS INSTALLED!
• Lifting the Welder by the top handle with welding gas cylinders installed could result in failure at the mounting points and the Welder
dropping. If the Welder needs to be lifted by the handle, remove the gas cylinders first.
FIRST AID
• If exposed to excessive fumes move to an area with fresh air. Follow safety information on the welding wire, tungsten electrode,
filler rod and stick electrode manufacturers’ Safety Data Sheets.
• For other injuries follow basic first aid techniques and call physician or emergency medical personnel.
SAFETY INFORMATION
CONNECTING THE WELDER TO A POWER SOURCE
The Eastwood Elite AC/DC MP200i Welder requires a dedicated 240 VAC, 50 AMP, circuit breaker protected outlet. The plug installed on the Welder is a
NEMA 6-50P and should be used with a NEMA 6-50R receptacle. If unsure about your electrical setup contact a licensed electrician.
As an alternative, by using the included Adapter Cord, the AC/DC MP200i can be used with a dedicated 120 VAC, 20 AMP grounded NEMA 5-15R outlet protected
by a circuit breaker.
If using an extension cord is required, we recommend using our Welder Extension Cords for optimal performance: Eastwood items #31739 25ft Heavy Duty
110V Extension Cord, #20029 25ft Heavy Duty 220V Extension Cord, and #20285 40ft Heavy Duty 220V Extension Cord.
Содержание MP200i
Страница 1: ...AC DC MP200i WELDER ASSEMBLY AND OPERATING INSTRUCTIONS Item 65375 ...
Страница 31: ...To order parts and supplies 800 343 9353 eastwood com 31 DATA CHART ...
Страница 38: ...38 Eastwood Technical Assistance 800 343 9353 tech eastwood com NOTES ...
Страница 39: ...To order parts and supplies 800 343 9353 eastwood com 39 NOTES ...
