Eastwood MP200i, Руководство по сборке и эксплуатации

Страница: 13 / 40

To order parts and supplies: 800.343.9353 >> eastwood.com
13
FIG. 12 FIG. 12
FIG. 13 FIG. 13
INSTALLING THE WIRE SPOOL
The Eastwood Elite AC/DC MP200i can be used with either a 4” or an 8” wire spool.
A 4” Spool fits directly on the Spool Shaft and the included, pre-installed 8” Spool
Adapter must be removed and placed in a safe location for future use.
To use the larger 8” spool, the included, pre-installed 8” Spool Adaptor must be used.
TO INSTALL A 4” WIRE SPOOL:
• Open the Side Panel Door of the Welder and remove the Spool Retaining Wingnut,
Spacer, and 8” Spool Adaptor from the Wire Spool Spindle
(FIG 12)
.
• With the wire feed oriented forward and from the underside of the spool , slide
the 4” Wire Spool onto the Spindle and reinstall the Spacer and the Spool
Retaining Wingnut
(FIG 13) . Then place the 8” Spool Adaptor in a safe place.
DO NO T unravel wire at this point.
SETTING THE WIRE TENSION ADJUSTER
• To set the tension on the wire, incrementally tighten the Spool Retaining Wingnut
at the center of the Spindle until there is a slight resistance to spinning the wire
spool on the Spindle. If the tension is set too loose the wire spool will freely spin
on the shaft and unspool all the wire. If the tension is too tight, the Drive Roller
will have difficulty pulling the wire off the spool and some slipping may occur.
TO INSTALL AN 8” WIRE SPOOL:
• Open the Side Panel Door of the Welder and remove the Spool Retaining Wingnut
and Spacer from the Wire Spool Spindle.
• Slide the included 8” Wire Spool Adaptor into the center of the Wire Spool.
• Reinstall the Spacer and the Spool Retaining Wingnut.
• With the wire feeding forward from the underside of the spool, slip the Wire Spool
onto the 8” Wire Spool Adaptor. When doing so, be sure the Drive Pin of the
Adapter is engaged with a spoke of the Spool.
• Set tension on the wire as noted in above steps.
Wire Feed Wire Feed
Orientation Orientation
✓