Eastwood MP200i, Руководство по сборке и эксплуатации

Страница: 27 / 40

To order parts and supplies: 800.343.9353 >> eastwood.com
27
STICK WELDING SET-UP
POLARITY SELECTION
The Eastwood Elite AC/DC MP200i can weld in both Direct Current Electrode Positive
(DCEP) and Direct Current Electrode Negative (DCEN). The electrode, or rod, when
welding in DCEP is positive and the grounded surface is negative. This polarity is used
with electrodes that specify it and is the most commonly used polarity when ARC weld-
ing for general purpose use. The electrode when welding in DCEN is negative and the
grounded surface is positive. This polarity is used with electrodes that require using
this polarity and is usually used for building up heavy deposits of material with less
penetration.
ARC (DCEP)
• Utilize the
Mode Selection Button
to put the Welder into DC Stick mode.
• Locate the Ground Clamp with 14.8’ [4.5m] Cable [F] and connect the plug
on the cable end to the ( - ) Ground Connector [b] on the Front Lower Panel
of the Welder. To connect the plug line up the key on the plug with the keyway
on the socket of the Welder, insert the plug and twist clockwise until it is tight
(FIG ARC DCEP) .
• Locate the Electrode Holder with 14.8’ [4.5m] Cable [H] and connect the plug
on the cable end to the ( + ) Electrode Holder Connector [e] on the Front Lower
Panel of the Welder. To connect the plug line up the key on the plug with the
keyway on the socket of the Welder, insert the plug and twist clockwise until it
is tight
(FIG ARC DCEP) .
ARC (DCEN)
• Utilize the Mode Selection Button to put the Welder into DC Stick mode.
• Locate the Ground Clamp with 14.8’ [4.5m] Cable
[F]
and connect the plug on
the cable end to the
( + )
Electrode Holder Connector
[e]
on the Front Lower
Panel of the Welder. To connect the plug line up the key on the plug with the
keyway on the socket of the Welder, insert the plug and twist clockwise until it
is tight.
• Locate the Electrode Holder with 14.8’ [4.5m] Cable
[H]
and connect the plug on
the cable end to the
( - )
Ground Connector
[b]
on the Front Lower Panel of the
Welder. To connect the plug line up the key on the plug with the keyway on the
socket of the Welder, insert the plug and twist clockwise until it is tight.
FIG. FIG.
ARC DCEP ARC DCEP
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
Turn the ON/OFF Switch [h] on the Rear Panel to the OFF position
and unplug the Welder from the power supply before beginning
welder set-up.